CoolIT Systems

i have seen your new Omni A.L.C. GPU cooler and i love it, its just that i have an antec 1200 rig, and it allready have a 200mm fan on the top. so will the Omni A.L.C. still fit in with my antec 1200 rig?

and also. i have not seen a pc with this installed from the top. does it suck air out from the top? or does it blow it down into the computer?
if it does blow up. do i then need to cut a hole in the top to be cable of putting your system on?

could be nice with some more pictures of this product, and see how its mounted

JBV,

Thank you for your interest in our product. The Omino ALC should be able to fit in the top of your chassis however you would probably have to remove the 200mm fan. If the fan is part of the chassis then it may take some modifying. If you were looking at getting a new chassis you may want to look at the TJ09 or maybe a Cosmos chassis, since you can fit a 240 MM radiator at the top of both. The ideal set up for the Omni ALC is a push pull method that sucks around out of your chassis through the top. The hot air that is blowing up from the 240mm radiator should be ok to leave out of the vent for the 200mm fan. More pictures will be available in May once we have stock of the unit. I do have a picture of a 240mm radiator installed into a Silverstone TJ09 chassis if this works for you.

TheJon

i think ill need to put it on the side of it, because i am not looking for a new chassis, and the dimensions of this on is 582mm (H) x 213mm (W) x 513mm (D) so i wont be able to put it inside the chassis

I have see other 240mm radiators install on the back pair of 120mm fans in an Antec 1200 case. Here is one shot.

[img]http://forums.bit-tech.net/picture.php?albumid=648&pictureid=7426[/img]

ill try that, when i get it. thanks for the reply